this issue hasnt gone away for me... did i miss something?
the classic square tube steel column 2 legged carport problem, and im tasked with anchorage design on an existing sonotube concrete pillar.. you know the drill
2.5 overstrength will blow things out and using 1.25 ordinary vs 2.5...
Coastal California, Seismic Zone D / E weight of the unit alone can be determined to counter the lateral loads for wind and seismic. but the isolated uplift load presents a problem. rather silly IMO. are we supposed to apply .2sds to an entire house and pretend in actuality that if there...
Building depts require steel storage containers be held down to the ground. We can make overturning and sliding work with just the weight of the unit itself. However, the vertical seismic that is reuqired (the ASCE v=0.2SDS x W) is where things get silly.
Lets just say that 600 pounds per...
thread507-373610
well then! ok... what the hail is going on here? correct? https://structuralcalc.com/rebar-development-length-calculator-to-aci-318-us/
36" overlap required? #5bars, 3000 psihttps://files.engineering.com/getfile.aspx?folder=ef40aa95-bdf9-43fb-a1fb-9d999c479a30&file=Capture.JPG
contractor wants to use 8" block and no bigger than #5 bars. as opposed to pilastering,butressing, etc..., I cant figure what would be wrong with bundling (2) #5 bars for the verticals, or (2),then (1) every other course staggered? thoughts? ready set go...
(edit- for clarity at...
i’m trying to explain to junior engineers why you can’t have a tall interior stud wall (like 24’) with the stud walls broken with a horizontal member midway i tell them that it’s a joint and out of plane loads (earthquake) loads will blow it out and it not proper construction to be done. but...
for metal buildings for instance, it is common to use the overstrength factor to avoid ductility requirements, etc in the ACI. overstrength is applied in order to design the bolt size and depth (also, there is a common design method to "ignore concrete breakout in tension and/or shear" by...
40 foot steel beam 2 supports at 28 feet,6 foot cantilevers, outer beam for a 6 foot deck/walkway support. Question: simple construction of wood joist to wood plate bolted to beam count for fully braced compression side? (also compression side switches on the cantilever).
Let the madness...
Kootk said :
The error in that logic is failing to recognize the difference between rebar development and rebar anchorage. Development is a component of anchorage in most cases but, on its own, does not guarantee that the bars will not pull out of the concrete. And, even if it did, that's...
appreciate the responses....the footing would have #5@12" EW @ btm of the footing the entire length. lets put it to bed, but as my last word in.. the development into the key might as well be an actual plate welded onto the bottom of the rebar and extended to udnerneath the footing, why isnt...
good gawd.... thread507-401855 i will never get that half hour back..... nevermind! i think that once you get your tension into the footing with the vertical rebar by hook or crook (ha pun.....like into the key even?), well then arent you essentially done with that force at least from a...
