According to the release notes, it was found that this issue only occurs in version 25.3.0. It seems to have been resolved in version 25.3.1. I have just updated the version, but I plan to upgrade again when I have time. Thank you, Luceid and everyone.
Luceid, thank you for your comment. I tried Draw Special Joint in the 2D-View, but I still get the same message. Also, I usually use Classical Plus (Standard?) for the graphics mode, but I tried DirectX and got the same result.
As shown in the right figure, modeling using the grid works without...
Hi, everyone!
I'm checking strength of beam structures using SAP2000. After upgrading to version 25.3.0, when I try to create a node by Draw Special Joint, I receive the message "An abnormal condition has occurred,” and SAP2000 terminated. This error occur everytime use Draw Special Joint but...
