I only have experience with methanol present in propane feedstocks and there it is intentionally added to prevent freezing of the free water present in this feed. The methanol can act as a poison for the catalytic reaction in the downstream process, handling the propane feed, and is therefore...
The pressure downstream the RO is the available back pressure plus the frictional losses between the orifice and downstream pressure source, calculated for the specified flow rate. The additional drop in pressure energy beyond the choked flow condition will be converted in other forms of energy...
When you design for example a flow control valve, the differential pressure is determined by the process system in which the control valve will operate.
Imagine you have a source at a pressure of 5 barg and a receiver at a pressure of 1 barg. The source and pressure are connected by a process...
The first step here is to determine the maximum inbreathing and outbreathing flow rates (thermal effects, filling/emptying of tank, ...). Based on this information and the MAWP of the vessel, the vent can be sized. The length and size of the vent determines the maximum over- and underpressure...
What does the suction side look like? Is the fluid pumped out of an atmospheric vessel? Do you know the static head? Is the amount of suction piping and corresponding fittings small?
Based on this information, the suction head can be estimated. As you know the discharge pressure, the TDH and...
Can you provide a PFD/P&ID of the system?
You can use a self-acting backpressure regulator at the end of the line which will prevent the pumps from dead heading. The valve can be sized for the full pump flow.
You know the inlet pressure and flow rates. The next step is to calculate the pressure drop, at the specified flow rates, in each segment taking into account al system components (pipe, fittings, steam trap, elevation, ...). The resulting pressure between the steam supply pressure and downstream...
The link below provides an example of a product bulletin for the MR95 pressure regulator series:
https://www.emerson.com/documents/automation/product-bulletin-mr95-series-en-122532.pdf
On page 9, the wide open coefficients are given. These are used when sizing a PSV for this particular type of...
@LittleInch: The shell is designed for 6 barg, which is the set pressure of the mentioned PSV (that's basically the only process related thing I know about this relief valve). The PSV is the only form of relief, no other form present. ODDR is the orignal design data report, the relief valve was...
Dear all,
I need your help in determining the reasoning behind a PSV in on of our water heating systems. The system is as follows: a shell-and-tube heat exchanger in which water (tube side, 6 barg, 20°C) is heated by low pressure saturated steam (shell side, 1,7 barg; 131°C) to approximately...
The pressure drop across the control valve is up to you as you know the system in which the valve is operating. Search for two points (up- and downstream of the control valve) in your system where the pressure is known. The pressure difference between those two points is the driving force in...
Ehzin,
I still have to check the presence of a bleed hole in the outlet piping of the PSV. If this would be the case, then I indeed believe the original designer assumed liquid relief in the beginning. After some time (HX discharge still blocked), steam would be relieved. Do you agree?
Orsiz
You know the flow rate. I would suggest to check the discharge pressure on a local gauge or transmitter. The suction pressure can also be checked or calculated. You then know the differential pressure and thus the required pump head for the given flow rate. Now select a pump that can provide...
Although these valves are FO, I think you can't exclude that these valves get stuck in the closed position. In that case, the pressure should be relieved via the PRV.
