If you are doing a stack-up to determine how far off-center a plug inserted into a hole can be, how do you handle it if the plug has O-rings? I have dimensional tolerances on the O-rings, but if the ID is shifted 1mm to the right relative to the OD, will the plug then be 1mm off-center as well...
I'm learning about GD&T out of a textbook somebody had at work and there are questions at the end of each chapter that I assume are meant to be discussions with the instructor. In the first chapter on position tolerance, one of the questions is, "When is it better to use coordinate tolerances to...
I'm working on an inspection fixture for a shaft that has a 0.02 Runout called out on the drawing. I'm not experienced in designing inspection gages and fixtures, so I've been reading up on it and I came across the 10% rule, that inspection gage tolerance should be about 10% of the tolerance it...
I'm working on a machining drawing and one of the features is a hole with multiple diameters (from 15, 18, 20, and 22mm) all along the same axis. Do I have to set a perpendicularity control frame for each dimension or can I set it for the top most dimension and have it apply to entire axis for...
I'm working on a hose routing project and since we're early in the design, the endpoints of the hoses and tubes are changing locations frequently. I've been using the Mechanical Routing application by setting up my datum points, creating a linear path through the points, and then assigning...
I'm currently comparing my assembly model to our real-world BOM, and I wanted to know if there was a way to collapse repeat components together within an assembly (for example, multiple instances of the same bolt), so that I can quickly verify the quantity of each item. Currently, they all show...
We recently upgraded to NX-9, and I've found that if I update something that breaks a bridge curve, when I fix the bridge curve, it disappears. Any later features that use the curve remain broken because I can't select the curve to fix it. When I right click on the feature it doesn't even give...
We just upgraded to NX-9 and I've noticed I'm no longer able to deselect "all of intent" any longer. For example, when I'm doing edge blends with the "tangent curves" setting, if I select a chain of edges that it's unable to blend, when I press Shift to deselect them, it only deselects the one...
