I have been requested to create the tool paths from a simple flat 3D model and I am wondering how to do this since I have never done this before in CATIA?
Richard D. Postak
Plastics Project Engineer
Toyota Motor Manufacturing Company - TMMK
tesak, thanks for the information and you're probably right. At this time I only have Catia running on a Unix system.
Richard D. Postak
Plastics Project Engineer
Toyota Motor Manufacturing Company - TMMK
Iscariot, no not on a cylinder. For example, take a look at a car tire and you can see how the raised letter on the tire are shown radially, this is what I am meaning.
Richard D. Postak
Plastics Project Engineer
Toyota Motor Manufacturing Company - TMMK
Hello again to everyone! This thread will most likely end up being several different questions regarding detailing in Catia. First question. How do I make my dimensions and text with labels to where the end of the leader is at the left center of the text and not at the bottom, which is what I...
Does anyone know how to insert text radially? I am on a Unix system and not Windows.
Richard D. Postak
Plastics Project Engineer
Toyota Motor Manufacturing Company - TMMK
Then that explains why I am unable to get that application to run. Again, thanks for all of your help!
Richard D. Postak
Plastics Project Engineer
Toyota Motor Manufacturing Company - TMMK
Tesak, do you run these applications inside of Catia, and if so then how?
Richard D. Postak
Plastics Project Engineer
Toyota Motor Manufacturing Company - TMMK
Hello, I need help with this subject. I remember doing this about 6-7 years ago and now I am in need of doing again. Can anybody please help me out with the process of doing this? As always, any help is greatly appreciated.
Richard D. Postak
Plastics Project Engineer
Toyota Motor...