Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by rohandpatil

  1. rohandpatil

    IPW visualization in NX 7.5 and NX 8.5

    Hello Ganesh I have already tried this option now the values kept are same default in my NX still i was not able to get desired output http://files.engineering.com/getfile.aspx?folder=c325824a-d154-4387-93c8-f9
  2. rohandpatil

    IPW visualization in NX 7.5 and NX 8.5

    Hello markief Can you let me know, where under customer defaults I can control the above specified changes. You may also provide me a snapshot of same for the right default values to be set. Thanks
  3. rohandpatil

    IPW visualization in NX 7.5 and NX 8.5

    Hello, I have a problem in visualization of IPW created in manufacturing in 3d visualization I get different views in NX 7.5 and NX 8.5 for same process followed I require output as 7.5 image in NX 8.5 Currently using NX 8.5 can any one guide me to get it. Let me know if i need to make...
  4. rohandpatil

    Inch " marks on Dimentions

    Thanks jerry1423 & JohnRBaker I used same steps before asking the question. I asked question just to know if there was any option available to get it automatically, like JohnRBaker replied with. but unfortunately it works with fractions only. Thanks for your reply
  5. rohandpatil

    Inch " marks on Dimentions

    Hello, I have a question in NX 8.5 Drawing. For example: - I have a NX part with basic unit inches. - In this part I created a drawing - The dimension is shown like: 4.7244 - is it possible to display like this: 4.7244" I am able to get this " output manually editing the text. Wanted to...
  6. rohandpatil

    Multiple Break-out Section View on single view

    Hello, I am using NX 8.5 i have observed some problem while creating Break-out Section View I want to create three "Break out" in the same view but there are several edges that appear after creating second Break-out section view The first "break out" it's OK. I create the second "break out"...

Part and Inventory Search