Where and how can I look for mentor on the below subjects.
Review gas compression system design.
Prepare compressor design, engineering, and performance requirements.
Perform technical evaluation of gas compression systems, and recommend optimum selection.
Prepare technical specifications...
What is the significance of Shell recruitment requiring skills in Mechanical Seals & flush plans ?
Usually done to seal vendor specifications and maybe sometimes attended by Shell staff.
https://jobs.shell.com/job/singapore/rotating-equipment-engineer-asset/25244/68189581136
Referring to ASME PTC-10 Performance Testing of Centrifugal Compressor , is the control panel tested together in the test stand together with the string ?
https://www.turbomachinerymag.com/view/myth-an-asme-ptc-10
A customer insist to have his gearbox level to 0.042 mm / m.
It is part of a gas turbine compressor
The same gearbox is used in floating production unit , which in nature could roll , yaw and incline .
Question is what could go wrong if the leveling is slightly out of limit ? ( 0.20 mm/m )...
Why labyrinth seal only operate on 5/s velocity ?
what happens velocity is more than 5m/s ?
what happens velocity is under 5m/s ?
http://docs.codecalculation.com/mechanical/seals/labyrinth-leakage/help.html
Can the dry gas seal be installed before the main piping is connected ?
Concern is main piping fabrication usually take a one to two months before it is ready to be installed.
If the dry gas seal is installed early, how can the dry gas seal be preserved properly?
If the seal is installed after...
How can I gain the below experience as turbine mechanic ?
Accountabilities/Responsibilities:
Participate actively in Company HSE programs and contribute freely to the achievement of the Company’s HSE policies and objectives. Through personal commitment and involvement, contribute to the safe...
edm123 (Mechanical)(OP)
If there is redundancy designed into it, the unit can still run.
If not, the unit will always trigger Alarm , Trip or not allowed a re-start .
I am trying to calculated power requirements from the below data.
However , I am not able to enter data specific gravity below 0.5
The gas molecular weight given to me is 11kg/kmol.
What is the specific gravity ?
https://catsolar.my.salesforce-sites.com/GasCompCalculator
How is it possible to inject naphtha and wash dry gas seal ?
https://www.eagleburgmann.com/en/products/mechanical-seals/compressor-seals/gas-lubricated-seals/rigiseal
