Recent content by shakila21

thanks for your reply IRstuff. player shows the movie but i slow rate and laptop fan stars to go faster with load noise due to hot temperature. I asked my question from some other people and they said one way to solve this problem is to find a decoder which could extract mp4 movie from gem file...

agian thank you IRstuff for your recommendation. unfortunately this type of move(GEM file) which is run in gem player does not let recording. if try to record the screen it will be recorded all black.

thank you for your reply IRstuff. unfortunately I could not find the one which support GEM file till now...

thank you IRstuff for your reply. I have searched in google and nothing works... those website just convert movie below 200Mb. Thanks anyway

hi I have a series of movies in GEM format which can only play by GEM player. the problem is my system graphic is low and it can`t play these GEM files in 1080 resolution.so I need to extract these Mp4 files which are within GEM files and change it to 480p resolution. Is there any way or any...

Dear HTURKAK, thanks a million for going through all trouble to find those references. Dear LittleInch, thank you very much for following the thread. I still searching about this topic. Dear R6155, thank you for your reply. yes, this is another point of view but as you can find in below links...

Dear HTURKAK, Thanks slot for your response and attention.

Dear LittleInche, thank you very much for your detailed response. I really appreciate it.

Dear Jstephan and Dear LittleInche, thank you for your reponses and attention. recently there is a discussion between me and some friends about Api being a design code or standard. I searched about the difference and found some information like...

thank you LittleInch. however I need more response. I personally think this is a design code...

hi can anyone tell me Api650 is a design code or standard? please answer with reference. thank you in advanced

Thank you Geoff for your complete description. I will go to let them know.

Thank you Stephan

reinforcement pad is mentioned in Api620 5.16.there is a part which I do not understand. in figure 5-7 there is a formula for pad length: greater value of (d+2c)/2+ (tn-c)-(tw-c) and (d+2c) but 5.16.3.2 says a) A distance equal to the diameter of the opening after corrosion; in the case of...

hi I need to calculate nozzle neck based on Api 620. the related part in API 620 is 5.19.2 Minimum Thickness of Nozzle Neck which says: a. The thickness of a nozzle neck shall be computed for the applicable loadings in 5.4, using allowable stresses as specified in 5.5, and to this thickness...