Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Sicilian Engineer

  1. Sicilian Engineer

    Belt Driven Industrial Robotic Concept

    Thanks, I'll look into this, key issue will be keeping time and cost down as much as I can (but you can't always have cheap, fast AND quality)
  2. Sicilian Engineer

    Belt Driven Industrial Robotic Concept

    Thanks boss, I have actually seen this one but I'll take a closer look. I am somewhat worried about fabrication for something so complex (honestly even machining for the capstan looks non-trivial) Either way if this has to be done it has to be done Cheers
  3. Sicilian Engineer

    Belt Driven Industrial Robotic Concept

    Thanks for this I'll give it a go. In the gates power design soft When I input my parameters it comes out with options (most with ridiculous pulley sizes or belt widths) but then gives me the "no products available" indicator which is somewhat worrying tbh.
  4. Sicilian Engineer

    Belt Driven Industrial Robotic Concept

    I can't afford harmonic drives unfortunately
  5. Sicilian Engineer

    Belt Driven Industrial Robotic Concept

    Hi All, I'm looking for some advice on this robotic design I'm working on. Mostly with the transmission. The motion of the system is as shown in my little vid below. For reference the links are approx. 1.5m, and one can say there is a 600N point load in the centre of the horizontal link. I...
  6. Sicilian Engineer

    Mechanical Design of Injection Moulded Products for 'Consumer Electronics'

    Thanks Bella, I appreciate you taking the time to respond. We are still in early prototyping but depending on client wishes I may get back to you. Thanks again
  7. Sicilian Engineer

    Mechanical Design of Injection Moulded Products for 'Consumer Electronics'

    Cheers SWC, I do have a company for this but they are based in a different time zone so can be difficult to work together effectively.
  8. Sicilian Engineer

    Mechanical Design of Injection Moulded Products for 'Consumer Electronics'

    Hi Engineers, I am a recent-ish graduate working in a super varied role doing product design. A lot of these products require injection moulded enclosures I have read the bayer guide for df injection moulding but am looking for other tips and general good practice to consider In my work going...

Part and Inventory Search