Recent content by Siddz

Hi, In cooling tower here is an side stream filter to reduce TSS the inlet water TSS is 80 ppm and the outlet TSS is 54 ppm we have required less than 30 ppm. Can any one share the sizing detail or pdf which help to design the new side stream filter please share the creteria of designing. THANKS

all material is vailable except flow

we need to calculate the heat duty of heat exchanger at cooling water side but i have no flow meter so how can i cakculate this flow rate , i have non pipe size

georgeverghese yes draw off is going to stripper and dont share P&ID because its confidential , but i share the tray photos as soon as possible

Hi, hope you all are fine. I have a question is that , crude ditillation column is open after four years. All trays is in good condition but the drawoff of kerosene plate is damage even its not able to use much more what was the purpose of this damage in kerosene plate .

hi, I am fresh graduate chemical engineer working in refinery. any one guide me how to set the plant parameter preflash , furnace, CDU pressure and temperature how will decided this parameter, which factor is under consideration. please guide me and any document related this send me I am very...

thanks to all

Hi, hope all you are well. Any one work on process envelop of refinery its means that work on damage mechanism in refinery, such that the top product of CDU is naphtha what was the effect of naptha at which temperature in pipe and the composition present in it cause which effect. Any one which...

can any one know tha boiler calculation and also guide me the which factor can effect boiler performance such as stack temperature and many others.