Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by SuhyunOh

  1. SuhyunOh

    Alternativeof external pressure calculation (external pressure dumped up to calculated pressue?!)

    Hi, PV Gurus, My pressure vessel manufacturer calculated thickness based on; Calculated Pressure by adding up External Pressure and etc. to Internal Pressure Did only internal pressure calculation (UG-27, AS1210 Cl. 3.7.3), without separate external pressure calculation (UG-28, AS1210 Cl.3.9)...
  2. SuhyunOh

    Is U stamp mandatory in Western Australia

    If Pressure vessel applies ASME Sec.VIII, instead of AS 1210, is U-stamping mandatory? Could I know where it specifically specifies in the national regulation (or DMIR publishment)? Many thanks.
  3. SuhyunOh

    Is U-stamping required based on ASME Sec.VIII?

    I've done several works applying ASME Sec.VIII Div.1, without U-stamping. Here I am told that U-stamping is mandatory by ASME code. Is U-stamp mandatorily required by ASME Code, or is it depends on the project(based on owner requirement/national regulation)? If it is not mandatory, could I know...
See more

Part and Inventory Search

Back
Top Bottom