Mark, your answer pointed me to the right spot. I was turning it on a second time. I went into the Speed & Feeds within the Teach "Profile Operation" and set it to none. That totally fixed the problem. Thanks for your help.
Mark, thank you for responding. Yes. The RPM is already running, then I make a rapid "Linear Move", then I make another "Linear Move" at .100 IPR, then I program a "Profile Cut" at .020 IPR. The spindle is turned on again before the "Profile Cut".
I don't want to turn it on again since it's...
NX 10 Lathe Programming Teach Mode --- How do I turn off the RPM output when using the "Profile Cut Selection". I have already turned on the spindle at the M00 restart and made several "Linear Moves" when I need the profile.
Lathe__80 deg. diamond tool- Rough cut down face & 1/2 of 1.750 radius. Turn extension dia. & the
remaining half of 1.750 radius. How do I make NX overlap the stopping point on the turning & radius
cut? Right now it stops at the same point in the radius for both cuts. I've tried all of the...
Mark Rief,
I believe that's a parametric canned cycle. I'm just using straight turning, facing and cutting
radii. I couldn't find anything on it in the training manual.
Thanks for clearing it up for me.
Curtis E. Wright
My post is in the notching mode (XZ) moves for cutting a radius.
I have the following filled out on the "Circular Move" data definitions page:
G94
G02
G90
X
Z
R
F
Also, on the machine tool page, I have checked "Output Circular Record"
I would appreciate any ideas to help.
Thanks.
Mark Rief:
This is turning and I have installed the attached "Avoidance Group" in my program (attached).
In the "AG", I have defined the Clearance (RT)=21.500 (attached).
I have all of the machining operations defined in the "Non Cutting Moves" with the same
"Clear Radial" in the Departure...
Here's the error I'm getting.http://files.engineering.com/getfile.aspx?folder=e9ca6b10-2d6e-4240-a211-4c4986be4976&file=Format_Error_2016-04-20_12-49-36.jpg
