Hi all,
in the project I am working on, I have analyze a sort of crew rest area. In one configuration of this monument, the crew will be sit and secured with 4 points seat belts.
My question is:
Is there the possibility to get the loads on the attachment points in all 6 loadcases...
Thank you rb1957 for your fast answer.
Yes you are right, it doesn´t matter to have multiple signs since the report is checked and approved.
It is a bit complicated because the data prepared by the other are not visible in the report, but I use them to make other calculation.
But here comes...
Hi all,
I have a question that concern the legal aspect of our work.
I am an Aerospace Engineer with 3 years of experience in stress. I work for a consultancy company and at the moment I am preparing a very complicated stress report for a costumer company. Since there is a lot of work, it has...
Hi all,
I run a model in which there is a glue contact. In the f06 I have these warning but I don't now how to interpret them:
*** USER WARNING MESSAGE 4690 (CNTGAPERR)
The gap between glue faces of some elements in gap pair 73 between
regions 3049 and 3063...
Hi,
I hope that someone of you can help me.
I realized a model of a partition in sandwich material that is connected to the floor through 2 shock absorber and on the upper part with two pins. The shock absorbers have been modeled with damper/cbush with coincident nodes that connect throug...
Hi everybody,
I received a very big complex to model. For one of the attachmetn I removed a very big fillet leaving an 90 deg angle. In the simulation I have a peak of stress in that area. Would it be possible to show through an analytical calculation the stress value in that area if there was...
Hi guys,
I am new in this forum and I have to say that from the discussions I learnd a lot. I am Marco from Italy.
I made a very big model in Femap with a lot of component modelled with shell. After an analysis a saw that this component is critical. Now I realized another model with the item...
