Is it possible to have an NX hole table show Negative values on the drawing. Ordinate is in center of part so i have some holes above and some below. Thanks
I cannot get the contact shown below to work, as you can see both contact arrows are facing outwards??? i tried switching the face normals and that didn't work
NX 10 advanced sim.
I am trying to show how i can remove the gravity sag/oval at the end of the tube by using the half moon shaped...
How can i add balloons to different sheets of the drawing that are linked to the parts list. I want to balloon a component on sheet 3 with the bom on sheet 1. I believe I used to do this using INSERT > Symbol > ID symbol but in my install of NX 10 there is only insert symbol Custom / Define...
ok got it working using extrude, would the next logical step be to use "create new" and select each body to represent a part. I try this and i cannnot get each body to save as a seperate part, i hate to do a sw comaprison but in sw you can split the body and name all the components and link...
My goal is to use top down modeling to design a frame then use split body to create the piece parts/coping then make a drawing that reflects all the piece parts. I can split with split body/planes but then it cuts across entire body, so the copes get messed...
Simple drawing in NX 8.5. Certtain dimension like an angle or bolt circle will shoot the dimension and arrows way off into space. If i wait 20 mins or so the pc unfreezes and shows the huge leader lines created. NX 8.5
I am modeling a boxed item as shown in attached JPegs. I analyzed using shell elements and am getting high loads specifically at the T intersection shown. Item is bonded in place around all 4 faces so i put a fixed constraint at these locations. Is there a better way to analyze the problem...
NX 8.5 advanced simulation. Whats the best way to simulate this connection, RBE3 from face to center then connect the 2 centers with some elements / rods?
New to NX/NX simulation but i must admit i LOVE it already. quick question what would be the best way to simulate a bearing constraint (similar to a bearing load). Ive tried point to face and selecting half the bolt circle and also spliting the face and doing a pin constraint, both seem to...
