So I am going to be posting this in both the mechanical and electrical section as I wasn't sure which would be able to help with this question as it could fall under both sides in a way. But my question is about a mechanical load block diagram which I need to make, I currently have a diagram...
That is true @waross and something that hadnt crossed my mind to be honest, I feel like finding the compared block for the magnetic powder brake will drive me crazy when it comes to PLECS as ive either missed the blocked or need to use something else in its place.
Ok so on further research I have come up with a new diagram but one I have not produced on PLECS just yet, the fun part will be finding all the block diagrams for what I need as ive never used the software haha. But basically I am going to have my three phase ac supply connecting to the stator...
Appreciate the informative reply @waross still unsure whether @s do work in replies. Also, I don't think I have given a proper insight as to what I am doing/want to produce, I'm basically wanting to design a three phase squirrel cage inductor motor which I currently have set up in PLECS as just...
@waross So I should be able to just add a three phase squirrel cage induction motor instead of a three phase motor and I should be good to go? I wish I had more experience with PLECS but its a new piece of software for me that I am still trying to get used to. Assuming PLECS have a squirrel cage...
I was just curious how far off I am with my current design from making my desired design. I want to produce a Three phase squirrel cage induction motor but I cant say I'm 100% confident on how to do so, currently I just want to run the design with default parameters before I start to change the...
@GregLocock
To try and sum this up, the code is for a synchronous demodulator model and I am trying to introduce frequency and phase deviations soley into the demodulator signal. Im going to be running the modulation depth at 5 and will be going through frequency offsets of 1kHz to 5kHz...
Hi I was just wondering if anyone could help me with my code, I am unsure how I would add a PhaseFrequencyOffset command. I read on MathWorks that you can use H = comm.PhaseFrequencyOffset(Name,Value), but I'm not entirely sure how id write this, as every time ive attempted it, it never has any...
Hi there, So to sum this up excel is confusing the hell out of me at the moment, I am attempting to make a P-v diagram in excel using a small amount of data recieved from a test. I will post what I am currently getting but basically all I need is for the graoh to plot point 1 at 0.001084 at...
