Thanks 0707
For vessel I understand that there is a National Board for each State that has STAMP requirements and exclusions
To be sold in USA, is an Accessory sufficient to be built following standards such as asme V, VIII and IX or must it be marked U STAMP?
To be sold in USA, is an Piping...
Good morning,
I am an inspector of an Italian body certification according to the PED (pressure equipment directive) 2014/68/UE.
I have questions relating to two different customers that would also like to sell in the USA
1)
A customer builds skids for the production of compressed air...
Good morning,
I am an inspector of an Italian body certification according to the PED (pressure equipment directive) 2014/68/UE.
I have questions relating to two different customers that would also like to sell in the USA
1)
A customer builds skids for the production of compressed air...
The linear "buckling module" is part of the Solidworks Simulation Professional package.
Non-linear buckling analysis can be performed with the Solidworks Simulation Premium package.
If the external pressure is present, the buckling shall be considered.
You should referer:
ASME VIII Div 2 5.4 Protection Against Collapse From Buckling
ASME PTB-3 2013 Example E5.4 – Protection Against Collapse from Buckling
For Simulation 1 (External pressure: 0.05 MPa; internal pressure: 0 MPa) ---> max Von Mises 1247 MPa
i think you should have used "buckling" module of Solidworks Simulation to find eigenvalue, von mises in linear analysis makes no sense.
