Search results for query: *

I started this thread here on the chemical engineering section as I was not sure if the people that may know something about chemical engineering actually followed the posts on the mechanical engineering site. This problem i am having has such a huge impact on my business that it may send me...

Hi all, I am seeking any information and advice on the process of chemical milling of mild steel. All responses greatly appreciated.

I am looking for advice on the process of chemical milling. All responses appreciated

Thanks so far for all the help. The problem is that the tube in question has already been fabricated in place and the unit has been powder coated and fully assembled. The cost of dissassembling and reassembly far out weighs the cost of the basic structure so it needs to be repaired in place...

Thanks mike, however I need to remove approximately 1mm in total from the I.D to allow a 65 x 65 steel tube to slide inside the whole way.

Sorry I should have been more specific. 75 x 75 x 5 (mm) square steel tube approximately 1300mm long with one closed end

Hi All, I need to ream / hone or grind about a mm from the inside of a 75 x 5 shs. All ideas appreciated