Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. drgauf

    allowable deflection in lifting beams

    Yes, there are codes for this. However they involve mathmatics for you to utilize them,... and for you to ask this question shows some education needed....
  2. drgauf

    Free standing stairs

    At top at bottom??? I think you are looking for stress stringers and the culmination point. Can you be more precise???
  3. drgauf

    Allowable shear stresses in shafts

    304 stainless can mean so much, be specific, manufacturer, state, location and time of manufacturing. Also look at the storage time and conditions of the stock. I fthe world was perfect than 304 would be also!!
  4. drgauf

    Set point for injecting coal tar in blast furnace

    Isuggest you refer to the "coke and smelters, a journeymans adventure", raed it, know it, then attempt to ask this again...
  5. drgauf

    Anchor Bolt Design

    Look to the ground-based technology references, this deals with natural securement and not mechanical. In fastenind anything to the earth, you must remember the earth is round and not square....
  6. drgauf

    Set point for injecting coal tar in blast furnace

    Remember that aluminum expands faster than SS under the same excitation
  7. drgauf

    Set point for injecting coal tar in blast furnace

    Can you elaborate on the material percentages?
  8. drgauf

    Vocabulary: Collet or Cotter

    Collet is a manufacturing tool cotter is a manufacturing component
  9. drgauf

    Stainless screw to Aluminum torque values

    Motor bracket is 6061, screw is 8-32 SS SHCS, threaded into 6061, torque spec is 8 ftlbs but totally insufficient, recomend 18?? Any input out there??
Back
Top