Specifying a Default Pen Mapping Table
The default pen mapping is always used unless another pen mapping file has been created and Pro/ENGINEER has been configured to use it. To specify the default pen mapping, remove any reference to pen table files from the config.pro and PCF files, and remove...
That does work. I was looking for a way to preview through pro wildfire, by picking the common space icon, but your way is good also.
By the way I posted this question in 3 different forums and you are the only one who answered.
Thank you very much
Frank
I have done all that you say. I still cannot preview a drawing. How are you previewing yours? That may my problem. Perhaps I don't know the proper way to preview in common space!!!
Hello.
I would like to browse my drawings contained within the common space directory before opening, but unfortunately when I click on each drawing no preview is
available, so I end up opening drawings just to see the contents. I have my config.pro set to Save_drawing_picture_file embed
I...
Sorry, I just looked back at this post and you are right my config.pro is duplicated again. Now I have to figure out which half to keep. I don't know why this is happening. If it happens again I will call Rand, we do have the maintenance agreement.
I worked with UDF's quite a bit in the past back on version 10 and 11. At that time when creating the feature we had several choices with the dimensions. They could be setup as Read/Write, Read only, or you set them so the dimension would not show unless you went back to the starting part for...