Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. newmike

    Restart/Next Step for Thermal Analysis using Node Temp?

    Here's the update: Well today I called ABAQUS. They suggested a subroutine URDFIL that would allows you to stop an analysis based on results from the previous iteration (uses the .fil file). They said in version 6.8 they will have flags that you can set to make this more user-friendly.
  2. newmike

    Using Matlab in Abaqus

    Ok, I did something similiar recently. Took a good effort to get the thing running for different geometry. Depends on what you need exactly. IN A NUTSHELL: I would advise you to (assuming you are using CAE) redo everything in CAE and then take a look at the .rpy file (should be in the...
  3. newmike

    Restart a finish analysis from a defined step

    This should be possible with the *RESTART card. Are you using CAE? If so, both jobs need to be in the same .cae file.
  4. newmike

    Restart/Next Step for Thermal Analysis using Node Temp?

    Hi guys, I have a basic 2D transient heat transfer problem where I have a concentrated heat flux at a node. Currently I have it run in Step-1, for 10ms. And then the heat source is removed and it reaches steady state in Step-2. But in reality it will run for as long as it needs to such that...
Back
Top