Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. mgiani84

    FLOW VOLUME IN AUTOPIPE

    Hi.. I´m using Autopipe to make a stress analisys. I have to test diferent flow volumes in a system and I don´t know how to enter this data in the software. (for example cubic meter per hour or gallons per hour). We are changing the piston of a pump and we have to test if the new flow volume...
  2. mgiani84

    SOME QUESTIONS ABOUT ASME VIII

    Hi, I´m still working with the design of a vessel using ASME VIII. I have four questions about some information of the code. 1-In what part can I find the maximum allowable loads in nozzles? (I mean the axial load and circunferential and longitudinal moments) 2-What about heat treatment...
  3. mgiani84

    Minimum design pressure

    Hi, I´m designing a vessel using ASME VIII and a I want to know if there is a minimum design pressure that I have to consider. The design pressure of the process is 22 PSI. Can I use 30 PSI or I have to use a bigger value? Thanks, MG
  4. mgiani84

    Arc spray with organic cover

    Hi, I have to aply a corrosion protection to a tank which will work with H2S. I was thinking about an arc spray cover with some organic cover paint. My doubt is about the thckness that I hace to give to the arc spray protection. Is 1mm an adequate thickness? ; Is Zn a good option for the...
  5. mgiani84

    Cover paint over Arc Spray (Zn)

    I´m studying the possibility of aply Arc Spray with Zn over a carbon steel tank. After that we have to aply an organic cover paint over the Zn. Do you think that the surface will be the most suitable for the cover paint? Have anyone some experience doing this kind of combination? Thanks for...
  6. mgiani84

    Grid Inside a vessel

    hi, I´m trying to put a grid to support a load inside a vessel. I suppose that COMPRESS has some types of grids preset in its library but I cannot find it. How can I make this operation? thanks, regards
  7. mgiani84

    Material for a sulfatreat vessel

    Thanks, MJ. Attached is the vessel datasheet that could be installed, what is your opinion about that? What do you think about the mechanical properties of FRP for this application? I ask you about this because of the sulfatreat loads. The datasheet is in Spanish, I can translate it if you...
  8. mgiani84

    Material for a sulfatreat vessel

    I was thinking in a fiber glass reinforced plastic, but I don´t find any example of this.
  9. mgiani84

    Material for a sulfatreat vessel

    Hi, I´m looking for a material to build a sulfatreat vessel. I know that the most suitable is a metalic one but now I have to design it with a plastic material. Do you know what kind of material can I use? There are some cover paints but I don´t know if it works.. Thanks for your atention
Back
Top