Search results for query: *

Is this the same as Alodine? I used this on the boat before. Can I just sand the surface, whipe with MEK and then wash with Alodine?

I know that the surface prep of Aluminium is vital, but the suppliers of adhesive don't seem to agree. Loctite's rep told me to just clean with MEK! Can Iask for a recommendation ? Please!

Hi guys, I have some EPDM non slip sheeting that I want to put on the deck of my aluminium (un-anodised) yacht. Can anyone recommend an adhesive system?

"Assuming the rubber has a density of 1.0 and the Magnetite 5.0 you need 83 weight% filler to get a composite with a density of 3.0 g/cm3." I can't see how one could get such a high filler loading? I need to find a filler with an sg of about 12.

It's for a mining application where they Ned to simulate ore densities. I need to match the s.g.'s.

I don't think my moulding machine would like this though.

We do need the sg of 5. We have looked at using Soft iron powder as used in Sintered metal components(sg7.8)but the part should be non-metallic.

Hi, I have a client who is wanting us to mould parts in a Thermoplastic Rubber with an S.G. of 3.2 (and other parts with even higher SG's). I have a compounder nearby who can compound the material for me, but he only has experience with Barium Sulphate that will give us an sg of about 3. any...

Hi, I need to run a job in HTV Silicone rubber with an SG of about 5. Any idea of fillers that I could use for this? I will need something that is reasonably priced and freely available. It will also need to run through my injection machine.

Hi Pat, sorry I'm new to the forum and I seem to have posted the question twice. I have no idea how to get rid of the duplicate.

The part is basically just a carrier, so there isn't much force involved. Room temperature, black(so this would add some stability,no chemicals involved really. It just sits in the wastewater discharge from a sewerage treatment plant and cleans the UV emitting tubes sterilizing the water. I am...

I have been asked to mould a replacement part that is used in a UV sterilizing plant. The part holds a rubber wiper that cleans the glass UV tube. The part is about 15 mm from the tube so it's getting a really good dose of UV! The part supplied is made from some kind of fibreglass filled...

I have been asked to mould a replacement part that is used in a UV sterilizing plant. The part holds a rubber wiper that cleans the glass UV tube. The part is about 15 mm from the tube so it's getting a really good dose of UV! The part supplied is made from some kind of fibreglass filled...

Thanks, but I am concerned about it effecting the properties and I also need the mix to be FDA approved for food contact. Do you know of a metal powder that would meet this?

Anyone know how to make Hot cure Silicone Rubber metal detectable? We want to mould some seals for a bakery and the parts need to be able to be detected by their metal detector in case they break up and land in the bread.

Thanks Dwight, I am waiting for samples from Lord Chemical at the moment, but I wondered if there were any other suppliers of similar products?

Hi, Is it possible to bond steel to thermoplastic rubber while overmoulding the steel in an injection moulding process?

Hi, Is it possible to bond steel to polyethylene based thermoplastic rubber while overmoulding the steel in an injection moulding process?

Hi, Is it possible to bond polyethylene based thermoplastic rubber to steel while overmoulding using injection moulding?

Yes, new mould design.