Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Transmission ring gear repair
Thanks to everyone for replying. Here’s some more detailed info: Gear O.D. 7 3/4” Gear width 1 1/8” Tooth face height 1/4” Tooth face width 1 5/16” Damage w. 1/16” Damage h. 1/4" If my math is correct this makes the damage area about...- npb1111
- Post #5
- Forum: Gear and Pulley engineering
-
Transmission ring gear repair
Hi, Does anyone have any info on repairing helical cut ring gears? The damage is very minimal approx 1/16" x 1/4" on 3 of about 70 teeth. The damage is limited to the very outer edge of the teeth. The gear is (was)practically new. Damaged during differential swap. Replacement cost is about...- npb1111
- Thread
- Replies: 5
- Forum: Gear and Pulley engineering
