Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. HH Choi

    Would nut rotate by torque wrench even if completed by hydraulic tensioning

    Thank you for all, Regards,
  2. HH Choi

    Would nut rotate by torque wrench even if completed by hydraulic tensioning

    Well,, fastener length would not be a factor to rotate nut, in this case. It was not so long.
  3. HH Choi

    Would nut rotate by torque wrench even if completed by hydraulic tensioning

    It was not planned to use torque wrench at tensioned joint, but a informality check using torque wrench. I agree to have consistent method for tightening. But not sure what made nut rotate even if hydraulic tensioned per vendor procedure. Maybe it was not correctly ready and/or tensioned, or...
  4. HH Choi

    Would nut rotate by torque wrench even if completed by hydraulic tensioning

    Hi there, I would like to ask advice about applying torquing where hydraulic tensioning has been completed. One of reports describes that some nuts on flange joint are rotating (I mean tighten) by torque wrench (hydraulic or manual) when apply torque value per ASME PCC-1, even if it has been...

Part and Inventory Search

Back
Top Bottom