Hi,
I am modeling a microvalve made of PDMS, and I need to find the Mooney-Rivlin Hyperelastic Material Constants of this hyperelastic material (I am using a 2 parameter Mooney-Rivlin model). Does anyone know the two parameters? Or can someone point me where to find these information? Thank...
Dear all,
I am using Ansys to model a micro device which contains deformation of a Polydimethylsiloxane (PDMS) Elastomer. I want to use HYPER56, HYPER58 to model this hyperelastic material, but I can not find the Mooney-Rivlin Hyperelastic Material Constants (I am using a 2 parameter...
Thank you so much, MikeHalloran. These are very useful informations! You are really an expert. I also looked into a book "Handbook of Hydraulic Resistance", which is a very good book, but I did not get the information on pressure profile. Seems I have do just use simulate pressure...
Basically I want to model a valve using the orifice flow model. Water is used as the fluid. The temperature can be taken as room temperature. The downstream pressure is zero. The upstream pressure is from 0 to 100 kPa.
The microchannel has a cross section about 300 by 300 micron. There are...
Hi, all,
I am modeling an orifice flow (flow through a small hole in a microchannel) using CFD software. I have simulated the pressure distribution near the orifice and the pressure distribution on the plate.
Now I want to compare the simulation result to the theoretical result. Can...
I used Ansys 9 a lot before, and I am trying to model a FSI problem with Ansys 10 since it is better for FSI. But after installation of Ansys 10, when I run Ansys, the following error pops up: "Error execting Ansys. Refer to system-related error messages in the ansys online help. If this...
