Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. Ranulfo Martins Carneiro Neto

    ABAQUS job shows "Submitted" but it's not "Running". any idea about fixing this

    Hi, It happened to me few times. I resolved putting my notebook in airplane mode, that is, disconnect your internet. I hope helps. Ranulfo
  2. Ranulfo Martins Carneiro Neto

    Deepth in model 2D

    Hi everyone! Is there any way in Abaqus to represent the deepth? In my work it would be a deepth of a adhesive joint (attached). For this arrangement, there are many possibilities about deepth value, that certainly would get influence in the joint behavior. Best regards...
  3. Ranulfo Martins Carneiro Neto

    MESH REFINEMENT - ABAQUS - BONDED JOINTS

    Hi everyone, I'm working with bonded joints in Abaqus, modeling a single lap joint or similar. I know how to create partitions in substrates and adhesives, so I can get a better mesh (larger density) at the points of singularities (stresses peaks). I do not know yet how to get different sizes...

Part and Inventory Search

Back
Top Bottom