monkeydog/vims,
Thank you for your help. Even though the assembly is more complicated and I just presented it in simplest terms, just to understand the basics. I should be able to take it from here.
I appreciate your time and help.
Farid
monkeydog,
I appreciate your help.
From this point onward, I am assuming, I should pick such a range of tolerance that there will always be some clearance between the mating features.
Right?
Thank you.
FM44
Hi,
Can any one, please, answer the following question in laymen terms:
- if I am doing a simple "worst case" tolerance analysis, how many pairs of the extreme dimensions do I consider?
example:
I have a pair of bayonet hooks (plastic part), which are 2.00 inches apart.(with +/-.01 tolerance...
Thank you ALL, Robointern, Timelord, unclesyd, and Mike Halloran, for your replies. I will take your advise and use a combination of worm and spur gear for raising and lowering a 20 Lb weight. All action is manual and very slow speed. I am using the worm screw to simply give me a constant...
Hello,
Can any one, please, help me with the following series of questions:
1) can I use a set of worm and worm gears (both plastic) for an adjustable arm, which will support a load at the other end (T=300 In-Lb) ?
2)Can a worm/worm gear move in reverse ?
(The screw might be required to rotate...
