Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
undercut in cam pulley
Hi, Because the sample was made on bakerlite and it was injection moulded- so they had to make a copy of that, the job had a large Rad on it so it wasn't possible to bolt or roll flange's on. thanks very much for your help- chris81
- Post #5
- Forum: Gear and Pulley engineering
-
undercut in cam pulley
hi, thanks for the reply- would it cause any problems? i think the belt is about 40mm long and there is a 3mm gap then the flange. cheers- chris81
- Post #3
- Forum: Gear and Pulley engineering
-
undercut in cam pulley
Hi, I have recently had some Cam pulleys made for my Subaru impreza. I send the company that made my pulleys old bakerlight injection moulded ones to copy. When i recieved my new ally ones back they had a 3mm undercut next to the flange that was all turned in one piece. When i asked why...- chris81
- Thread
- Replies: 4
- Forum: Gear and Pulley engineering
