Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Mits. is the best on market
They basicaly have half the teeth and are larger teeth spaced farther apart. I will try to post the DXF or a link to them on here today.- MITS1
- Post #5
- Forum: Laser engineering
-
Mits. is the best on market
If you are still running the original design slats that came with your laser then yes you will have slug issues, We use a dif. design that eliminated that problem. I only have a slug problem if I run the slats for a month without cleaning them, when the slag builds up too much I just pull them...- MITS1
- Post #3
- Forum: Laser engineering
-
Mits. is the best on market
thread380-217519 I know this is old thread but I am new to forum and could not pass this up. I own a Mits. 3015LVPLUS and this thing is bullet proof !! There is no glass tubes to clean and there are no expensive blowers to replace. the design of this resonator is awesome. there is no 15k to 20k...- MITS1
- Thread
- Replies: 4
- Forum: Laser engineering
-
Tabbing Parameters
First off I am new to the forum so hello. I use .030 tabs on everything from .187 up to and including .500 approach is 90 deg. and escape is 120deg. My Mits. LVPLUS runs 24/7 lights out. When cutting 9/16 and 5/8 I change the gap to .050 and pre-pierce the whole sheet first.- MITS1
- Post #5
- Forum: Laser engineering
