Hello all,
I am working on a project that involves some pretty complex 6061 aluminum extrusions. The extrusion company is trying to push me to switch to 6005 saying that its mechanical properties are identical. Although I have found information that confirms 6005 T5 has similar tensile strength...
Thanks Unclesyd,
Sounds like 4140 might be a good choice as there are no high temperatures involved and I assume H11 would come with a higher price.
John
Thanks Heckler!
Dumb question #2
The one-way bearing requires that I have a 58 HRC 30mm OD surface for it to run on... The 17mm splined part of the shaft may not need to be that hard but is it more economical to spec a surface hardness of 58 HRC for the entire shaft surface rather than have...
Hi all,
I was woundering if you guys might be able to give me some advice regarding a shaft I am designing. The overall shaft length is only 4 1/2" and it will have a 1 1/2" long section with a 30mm OD and then step down to a 17mm OD with a spline at the end.
The 30mm OD section will have the...
