Thank you for taking the time to read my post.
I have a high pressure application (9000 MAX PSI) and I am having trouble finding correct fittings and wanted to ask if anybody can point me in the right direction.
I have a pump with a M14 1.5 male cone end that I need to connect to a electronic...
The purpose of this setup is to drive flow into a nozzle/orifice to cause cavitation. I specifically wanted to keep the supply and return tank separate to minimized the bubbles entering the line.
At the moment, when I run the flow circuit, I can already see large bubbles entering the orifice...
hydtools: can you elaborate on your points?
I am convinced that I am getting air trapped into the system. I believe a big source is through the test section. When I turn off the pump the nozzle begins to suck air into the line. What are some good practices or add ons that I can use to prevent...
Thank you for all the feed back.
I have included a diagram of the system (the flow is designated with the blue line)(please ignore the other items).
BigInch: The flowmeter required a specific length in/out of the meter. Although, I can rotate that pipe 90 degrees so everything is lower. I am...
Thank you for taking the time and reading my post. I very much appreciate your help.
I am getting bubbles into my pipe system and wanted to know how they are forming and what I can do to remediate.
The flow begins at the a reservoir holding water that is open to the atmosphere. Water flows...
