At the moment, the material is EN32. Probably not the best choice, but that's what our job-shop had to hand. They also attempted a rudimentary heat-treatment. The pin is bending. It has a very small recess in the end to help alignment. Unfortunately, the equipment that is available means that...
Hi everyone,
I'm NOT an expert of any kind when it comes to this arena, which is showing the restults that I am getting.
I have a 2.5mm dia press tool pin that is pushing in a small, steel part with an interference fit in to aluminium. Unfortunately, the steel part needs to be pushed down...
It is a variation of a legacy design which has worked for years. I thought that the question concerning shore hardness was a valid one, but I can't find any information concerning my original question.
Hi everyone,
I'm working a piston that will see about 50 bar, but will also see approx 1 bar vacuum. It has a stroke of only 25mm, a 18mm dia and a linear speed of only 2mm/sec. This change from pressure to vacuum will occur over a matter of just a few seconds.
I've been asked by the Chief...
I'm recently returned to Pro-E (Creo 3) after a break of a couple of years and I am having a problem getting the text on a dimension to behave. Instead of it sitting on the outside of the leader, the text goes back on itself. Any advice would be greatly appreciated.
G'day,
I have just moved jobs and on my new PC (a brand new build), strange things are afoot. When I dimension anything in a sketch, the dimension is if the format like this...3.65e+002, rather than 365mm. My machine is the only one like this and I have no idea how to change it.
Can anyone...
3DDave,
That's done it! Thank you very much for your help. I really appreciate it. I've been looking for this feature for longer than I care to remember.
Paul.
OOPS! Sorry, in a drawing using Creo Elements/Pro 5.
Thanks for the link. I've taken a look, but it seems to only change the line-type, not the transparency of the part. It would work if I could change the offending part to wireframe whilst everything else in the view is solid, but I can’t...
As the title suggests, I need to represent a sectional view of an assembly, but with one of the components as wireframe/transparent. The component to be transparent is a "potting" in a connector and I need to show the cables running though so that route can be seen in section. In SW I can simply...
Is there a way of representing the circular lines on a drawing if there are only two holes? The command doesn't really come alive unless three holes are selected. I need to dimension them radially.
Paul.