I have attatched to screen shots of a lifting frame I am working on...
I am struggling on how to fix it?
One screen shot shows it fixed through the lifting hole using a 'Fixed Geometry' fixture and a 'Distributed Mass' on top of the box section
the other screen shot shows it with a 'Fixed...
When calculation the 'stress' of a part... our Company standard is to calculate the stress at 60% of the yeild!
Is there a way of showing this on the chart as well as indicating the 'Yeild strength' which is shown as standard?
Does anybody have any suggestions for using SolidWorks on a Multi-Site set-up so everybody can use the same set of parts from the database?
SolidWorks are pointing our company in the direction of PDMWorks Enterprise! any other suggestions?
If you create a part model complete with dimensions...
when you add a scale to that model, the dimensions stay as the dimensions before the scale!
Is there a way to change the dimensions with the scale?
I want to add a percentage of a figure to a figure...
=SUM(A1+(A1*(40/100)))
If A1 = £10 then the answer would be £14.
but the minimum figure I want to add on is £10, so the answer I require is £20.
Therefore how can I write a statement which would calculate the original sum, but if it was...
How do I round down a number in an increment of 5?
Example:
if I have an aswser of £6.52... how do I round down to £5.00
or
if I have a answer of £21.06... how do I round down to £20.00
I only want to use £5, £10, £15, £20 etc. etc.
I am trying to create a spreadsheet for use when bidding...
I am trying to use the 'FLEX' tool...
I want to apply two flexes to a polyurethane disc representing the disc flexing inside a pipeline.
The problem is the flex tool flexes from the centre point... can you flex about a given radius from the centre point?
Excel 2002
I have a table of threads: M3 down to M10
I am using Index, Match to find specific information from the table relating to the thread for a calculation depending which thread I pick using data validation.
If I have the threads listed in the table from M3 down to M10, the selection...
the formula I am using is as follows:
=IF(29.99>=G21,G21*(5.25/100),IF(599.99>=G21,(((G21-29.99)*(3.25/100))+1.57),(((G21-99.99)*(1.75/100))+(1.57+18.53))))
I have formated the cell to 'currency', but another formuala in another cell uses the answer... the answer is not to two decimal places...
I am using an IF Statement to work out the cost of something... by doing this, it will work it out to umpteen decimal places (this messes up the spreadsheet to no end) and not the two decimal places required!
Is there a way of adding a ROUND into the equation to get the two decimal places required?
I have managed to construct the 'Wye' in terms of putting two pipes together and putting the relevant holes through!
What I am stuck on is generating the chamfers for the weld preperation... please take a look at the picture attached to see what I require!
Thanks
it is the chamfering which is causing the issue, i.e for weld prep as we have to get this wye tested and approved which includes a welding procedure...