Search results for query: *

There are two options in fillet in sketcher circular and circular trim. Hade gone through net but didnt understand exact difference and how they affect model. Kindly help

Lol, that was a difficult scenario. God forbid such in future.

Thanks guys. I really do appreciate taking time to revert on my childish queries. Hope you guys would carry on helping me and others the same way. V Thanki

Thanks a lot. I was looking for something like this file. Also I do have doubt does creating a separate sketch and extruding it provides any better advantage rather than directly selecting extrude and drwaing sketch inside.

Sure Thanks. Would ask later if any questions arises.

Thanks I would try the same. Just a small question does creating a part in single quadrant (quadrant in sense of planes and axis like first quadrant, second quadrant etc) provides and benefits over a component drawn over multiple quadrant?

Thanks 3DDave. Got your point. Its a long road rather than a milestone. Now that I have realised that, could you show the way to start like a book or tutorial that's like the Bible of Creo 5.0. Would appreciate a lot.

Hi everyone, I have been recently transfered to 2d to 3d conversion team for a heat exchanger firm. I just wanted to know about some key check Points that were to be kept in mind for these conversions. Additionally guidance on generally good model would be appreciated a lot. Creo version...

"A single conversation across the table with a wise man is better than ten years mere study of books." Respected All, Thank you very much for your precious guidance. @John R. Baker > No sir, I was jr maintenance planning engineer before corona. @Littleinch > Sorry for such a broad one, I'm...

When we carryout design calculation of any element, should we consider yield strength or ultimate strength as its basis for calculation ? Kindly also do guide me if the question itself is wrong.