Hello!
Could somebody prompt – how in the “NX 9 Advanced Simulation” translated meshes (copied, mirrored) can be joined each to other and to a carefully meshed original one to obtain a big entire model having some regular topology for analysis?
The copied meshes have not basic bodies so...
Yes, it is enough strange but it looks like really there are no ability in the "NX Advanced Simulation" to apply a simple linear load to an edge in a direct way.
Thank you, Tuw.
Hi!
Could somebody prompt please – how can I apply a linear load (N/m) to an edge of a 2D plate part. The system accepts correctly application of a force (N) to the subject edge, but if a linear load (called here as pressure ‘On beam’) is applied the following message appears during solving...
Blas, thank you very much for the clarification of the problem. :)
Tuw and mrfemap, thank you as well.
I think that although the variant with the ‘surgical’ nullification proposed by Tuw is a little bit risky it looks very practicable because of being realized accurately it gives us ability to...
Thank you for the reply.
Yes, a roller/slider is not shown below one of the supports on this picture, but the value below it are calculated correctly as for a 'classical' simply supported beam.
It can be checked by the following calculation:
==========
Beam length: L = 1.00 m
UDL : q = 200 kN...
Hello All!
In a simple calculation of a beam under uniformly distributed load I have got two times bigger value of deflection than expected (hand-made). At the same time the situation with values of reactions, bending moments and stresses looks OK.
I would be grateful if somebody point - what...