Get yourself a back setting tool. The rivet head is held with the gun and snap (with a bit of tape on to prevent smiling the rivet) (or a machined block) as per usual and with the tool (looks like a straight snap but with a nylon sleeve to stop the face moving off the rivet)form the rivet tail...
This product is specified in NA03-10ABG-39 (para 6e) maint manual for overhaul of dual float and vent valves fitted to P3A,B Orion aircraft. If I had the spec and data sheets that would be handy. Since these floats are cork and submerged in Jet fuel (JP5) and appear to have some flexible varnish...
I am trying to source an accepted aeronautical alt for Amercoat 1403. This is to seal cork floats on vent valves in jetfuel. I am trying to find info on Amercoat (contacted PPG) but maint manual says Amercoat or equivalent maybe PR1005L will suffice. Any ideas????
Saitaetdrad, I have 200 to do and yes the tapered anil is no sweat but the forming piece that has the rolled machine cutout is the hard bit for a freehand guy to guess.If I knew the radius of the roll groove that would be handy.
Thanks for your reply.
Kal
Thanks Bf109g. I am in NZ and the cost is a bit prohibitive.
Still trying to find a dwg of tooling. Guess it is like rocking horse poo to get.
Thanks mate
I am trying to source a tool and or drawings for the setting of MS20230 eyelets or grommets in some areas.
Most tooling around will set the commercial type with a straight barrel not the tapered type on the MS.
(AN230 was the old spec)
Size is 0 and it is a plain washer (Al or Brass per spec)...
On Jo Bolt (NAS1669 nominal)protruding head type I have installed iaw material thickness and selected appropriate grip in the various sizes I am using -3,-4,-5. The fasteners break off within limits and those that i can see have a good head form. Problem is they rotate. Now does anyone know of a...
I am trying to source an alt part to one that is prescribed in the IPB for P3B. Pno 920372-5. It is a water drain off the overboard bleed air duct and must conform to LAC-23-952.
it has dim of .5inch ID and .125inch wall thickness.
The spec states that it is tested at 400F and as it is close to...