Search results for query: *

Thank you very much I find the solution. I do not know why I totally forget this bulk modulus Thank you.

Good afternoon, If I compress crude oil from 1 barg to 25 bars how can I calculate the reduction of volume? Thank you.

Good Afternoon everybody, I would like to know if it is possible to simulate a well with PRO II. It is the only software that I have. Thank you. Best Regards.

Thank you BigInch. Does anyone have a software to do drop pressure calculation? I tried to do it manually and the result are very strange. I used the example 17.4 done in "Fluid and Flow piping" Section 17 I found a drop pressure of 6900 Kpa which is strange cause the inlet pipe pressure is...

Good Afternoon ! I would like to know when we flow gas and liquid (oil + water) in a pipem, what are the things which we have to be aware except drop pressure, line integrity? Thank you

Thank you very much it is very interesting to read your point of view. Actually I don't need an accurate value. That is why I wanted to do it manually. I have never work on this kind subject. I would like to give some details about the situation. The gas is coming from an MP separator and then...

Snorgy, I would like to do it manually. I read Section 17 in GPSA. I found the Flanigan Liquid Hold up correlation. For the calculation of the Liquid Hold up they just use the gas velocity. I try to do the calculatio I found about 30 m3 of liquid in the pipe. It's strange because they don't...

Good Afternoon, I have a question. We have a pipe about 9km. We send gas inside this pipe. I would like to know when we are going to have liquid. I know that we can use the Dew point. Even if I know that we are going to have liquid is it possible to calculate the volume of liquid? Thank...

Thank you !

Good morning, I would like to know where is the best place to install auto sampler in test separator? outlet liquid? or inlet? Thank you Regards,

Good Afternoon, Does anyone work with mass flowmeter such as micro motion. I would like to understand why there is a difference between the water cut done by the flowmeter and the water cut coming from labo analysis... Is it the gas effect? how can we correct this difference. Thank you...

PaoloPemi , Thank you a lot for all your explanation. I get the composition of the gas and I calculated the velocity. Merci again Best Regards,

Good Morning, Thank you PaoloPemi for your explanation. I have another question why do we consider natural gas? Thank you Best Regards,

Hello PaoloPemi, Thank you for your response. The flow rate is 10 MMscfd, the diameter of the nozzle is 6 inch...maybe I did a mistake in my formula. The density of the gas is 33kg/m3 and viscosity 0.0129 cp. I will try to see is the flow is correct. Thanks again Regards,

Thank you tickle for your response. Actually I thought also about this formula but as it seems too easy I was not sure... The problem is when I do the calculation flow / nozzle area = velocity I found 180 m/s.... too huge I think...

Good Afternoon, I would like to know how to calculate the velocity of the gaz in outlet nozzle of separator. It is a 2 phases separator. I have the flow, the density, the viscosity of the gas. Thank you for your help