Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. Bilbrough

    Plating / Coating for SmCo

    We regularly operate SmCo magnets in vacuums in the low e-6 torr with no issues at all. The only thing we have to watch for is ensuring the magnets do not heat up too much (due to typical operating conditions that we face) as there is no easy way to cool them in a vacuum.
  2. Bilbrough

    Quickfield vs Maxwell SV

    Force calculations are notoriously finicky in FEM. Make sure you have a very dense mesh before running this result then, to be sure, double the mesh and run it again comparing the results to the first time. If the results are significantly different then your solution is not converged and your...
  3. Bilbrough

    prices software 3d for magnetic analysis

    From my experience (having worked for one of them) you should probably expect to pay about $20000 if you pay list price for most of them but, the best thing to do is contact them.
  4. Bilbrough

    Looking for reputable Neo vendors. Any recommendations?

    I can give two suggestions for places: one is already mentioned here, Dexter. I used to know a few of the guys working there and I know they are pretty careful and do good work. Use them if you have a bigger project that requires a lot of materials. The second one is Dura Magnetics...
Back
Top