Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. raymondgajewski

    Creating a Tube in an Assembly

    That is correct. Both tube and piping have "connectors" built into the process. But, you/I can't select other components as reference points. (initial post)
  2. raymondgajewski

    Creating a Tube in an Assembly

    Thanks for the information. So you utilize 3D sketches for the piping/tubing runs you create? I wasn't sure if that was an easier way, seems to be.
  3. raymondgajewski

    Creating a Tube in an Assembly

    I see that for 3D sketching but not in XpresRoute and can't figure out how to add the command to XPRESROUTE. The "Edge Select" only shows up on 3D sketch's menu.
  4. raymondgajewski

    Creating a Tube in an Assembly

    In an assembly how do I pick a part to begin my pipe/tube run? I have an asm file that is the entire plant with equipment. I have a part drawing, in the asm, for piping. When I edit in place the piping file, I can't select any of the equipment in the plant layout part file. I can activate...
Back
Top