Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. mtweeman

    Bisector surface in CATIA

    Thanks for all responses. weavedreamer, I like your way the most. I tried it (a little bit modified) and it gives proper result. I'm presenting my way below. itsmyjob, the measures on my drawing were angles between surfaces - at the beginning they were 90 deg. angled. Later, as a result of...
  2. mtweeman

    Bisector surface in CATIA

    Hello! I have a model with two surfaces, which are intersecting. Looks like below: As you can see the angle between these surfaces changes as we go along the intersection curve. What I need to do is a surface in CATIA which will be bisector of the angle made by two given surfaces. Of course...
  3. mtweeman

    Drawing - help lines aligned with object

    Maybe additional question: is there any way to show lines that create this intersection points? I mean show them on final drawing.
  4. mtweeman

    Drawing - help lines aligned with object

    Thanks! This is what I was looking for!
  5. mtweeman

    Drawing - help lines aligned with object

    Hello! I have a simple CATIA part: On the drawing I want to measure dimension using some additional point at "virtual" corner: However, if I change one of dimensions, additional line stays in place it was put: I can draw additional lines to achieve this corner and use drive geometry to make...
  6. mtweeman

    Abaqus book - non-linear analysis

    Dear all, I'm curious if there's any good book that explains how to model dynamic problems, such as impacts, etc. I've been recently ordered to solve a problem of surface crushing a round, extruded profile, but I was unable to do this. So are there any books or tutorials that should be helpful...
  7. mtweeman

    Problem with conditions setup

    Hi, could someone tell me how to set a flat surface mass of 2000 kg dropped free from 5 m in Abaqus? I'm not able to do it correctly.

Part and Inventory Search

Back
Top