Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations IFRs on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. DanielDDirks

    The Attribute type is invalid.

    Thanks for the information John. I will contact GTAC. No, I was not a beta tester. We did meet at the Intermountain RUG meeting. Thanks again, Thanks, Daniel Dirks Mechanical Designer JBT AeroTech daniel.dirks@jbtc.com
  2. DanielDDirks

    The Attribute type is invalid.

    My company just upgrade to NX 9 initial release. As we have opened some legacy parts we are getting this error message. "PART NUMBER/- -The attribute type is invalid." Then the part does not open. Has anyone seen this and does anyone know how to get around it? Thanks, Daniel Dirks Mechanical...
  3. DanielDDirks

    Preferences change every session

    Thanks for the reply John, I will check to see if I have a registry problem. So, these are not setup in the templates? I was thinking our template was incorrect. Do I have to go to each computer to set these up so they all match? Thanks Daniel
  4. DanielDDirks

    Preferences change every session

    Hi Everyone, My company just upgraded to NX7.5 from NX3. I go in and change my preferences on section lines and view label. Then the next day all of the changes are gone back to a default setting. How do I change the preferences and make them stay? Not sure if it matters but I run NX7.5 with...

Part and Inventory Search

Back
Top Bottom