Preferences change every session

[DanielDDirks]

Hi Everyone,

My company just upgraded to NX7.5 from NX3. I go in and change my preferences on section lines and view label. Then the next day all of the changes are gone back to a default setting. How do I change the preferences and make them stay?

Not sure if it matters but I run NX7.5 with TeamCenter8. This problem is in both native and intergrated.

Daniel
Mechanical Designer

 

[JohnRBaker]

Preference settings are saved in the Windows Registry. Make sure that someone hasn't messed with them.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.

 

[DanielDDirks]

Thanks for the reply John,

I will check to see if I have a registry problem. So, these are not setup in the templates? I was thinking our template was incorrect. Do I have to go to each computer to set these up so they all match?

Thanks Daniel

 

[SDETERS]

You may want to take a look at the link below.

You will need a webkey.

http://bbs.industrysoftware.automation.siemens.com/vbulletin/showthread.php?t=42187&highlight=nx75