Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

selection preferences NX7.5 1

Status
Not open for further replies.

cadrebel

Mechanical
May 11, 2011
46
I am running NX7.5 When I pick an object it defaults to picking the group an object is in rather than just the object.

I have changed a setting somewhere because I did not have this problem before but I cannot seem to find it. This has been this way for a long time now so I cannot go back and see what I have done.

thanks
 
Replies continue below

Recommended for you

Pretty sure the defaults for that is in the selection intent rules of customer defaults. even that far back in 7.5
 
There is also a "Selection Priority" option in the "Top border bar - Selection"
I think that was invisible by default (? )
Where "Shift-F" was the shortcut for "feature", Shift-G = Face etc.

Regards,
Tomas

The more you know about a subject, the more you know how little you know about that subject.
 
thanks for the help ! This has been driving me crazy.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor