I am trying to use routing in different configurations. Is it possible to make them configuration specific? I have tried constraining the parts in the different configurations, but the wire becomes broken and floats away from the part in the other configuration (to the position I moved it to...
That is true, but the center point is the same. It would be nice if you could click on the center point and have it combine all the hole notes for the same hole or have the option of doing it separately for each diameter.
Thank you for the response.
However, I am referring to
a
drill xxx xxx deep
b
drill xxx xxx deep
c
drill xxx xxx deep
tap xxx xxx deep
where they are different diameter and depths but at the same place.
Is there a way to combine multiple holes in the same location into a single hole callout instead of multiple callouts all pointing to the same location? Thanks.
I am a coop. Thank you the angle fix worked. I found it odd it only did that for 45 degrees and not the rest. Whenver I input the decimal i immediately rounds it in the property manager and when it shows on the drawing it shows the round with a zero at the end. 1.875 > 1.88 > 1.880. No one...
I have Solidworks 2011 and it is rounding the decimal place for holes and angles.
I'll input 3.875 and it will show 3.880 when I put it to three decimal places.
For angles when I use a 45 deg angle it won't show any zeroes (like 45.00 deg) only 45 no matter how many decimals I set it to so I...
