Hey! I am fairly unfamiliar with watertight/waterproof dynamic seals and I was looking for some guidance on a project. My current design uses two tubes - 1 stationary and 1 that rotates approx. 90 degrees (back and forth) - and I need to create a low cost, low friction seal between the two...
Hello. I am looking for a plastic film with the following requirements: FDA approved/compliant, puncture and tear resistant/proof, withstand boiling potable water, and capable of being heat sealed to a variety of substrates. I have researched a variety of multi-layer polypropylene films but I...
Thanks for the responses.
I tried Loctite 480 a few weeks ago but the water interacting with the adhesive will be approaching 100 degrees celsius and the glue didn't hold - it's only rated to 82 degrees celsius. I called Loctite several times and I was told none of their products would work...
Hello,
I have been searching for an adhesive for bonding a polyethylene film to a natural rubber (I know, it's almost impossible) and I was hoping for some guidance. Before you say to give up, I have had great success with common super glues and, while my application does not require a strong...
I need the actuator to be around 50 mm in size but the shaft or pin to have a 75 mm stroke. I'm sorry for the confusion. I am new to actuators and the like.
I need the stroke length to be approximately 75mm and I would like the push/pull to occur at least 3-4 times per second. I looked into the micromo linear servomotors. Does anyone have experience with these? I need the pin to accurately move in one direction and come back to the same starting...
I am working on a project that requires moving a 100mm long and <.5mm diameter pin a specific distance in a straight line. I want to move the pin in and out as fast as possible and accurate to less than .05 mm. The device needs to be as small as possible. The stepper linear actuators on the...
