Search results for query: *

Dear all, I have a problem modeling a contact beam models. I am a beginning of the contact models. I attached a very simple model made by myself. Can anybody help me to check what is wrong with my model? Thank you very much for your time. Best Regards, Dovil FINISH /CLEAR,START *AFUN,RAD...

Dear Friends, I ran a drop test using the Drop Test Module in ANSYS/LSDYNA. But it seems like I can only read the time history of the displacements, velocities and accelerations for CG and Lowest Point. Does anyone know how I can read the time history data of DOF, Strains, Stress, etc., for...

Dear Friends, I have a problem when simulation a drop test in ANSYS/LS-DYNA. I was trying to drop a flat plate with linear elastic material properties, but the first rebound height is always as high as the original drop height, or even a little bit higher, but after two or three rebounds the...

Hello, I was trying to add time history of the nodal solution of strains for Shell163 elements. Then, I got such error message: The averaging done by the ANSOL command together with the RSYS,SOLU command assumes consistent coordinate systems for all elements used in the averaging. Shell...

Hi Drej, Thank you very much! I can use matlab to do it. You are right that I did not put any damping in my model, that might be the reason of the "noise". Thanks again.

Hello, Does anybody know how to smooth the output variables in ANSYS/LS-DYNA. I ran a drop test and got the acceleration of the gravity center, but the data contained a lot of noise, so I want to smooth the data. But I could not find any output variables in "Main Menu >TimeHist Postpro >Smooth...