Hi,
I'm working on exporting a large assembly to STEP file in Solidworks 2022. Unfortunately, SW is unable to process it. We are trying to make some assemblies Virtual and tried again, still it taking days to convert to STEP file.
Any other easiest ways to do it? Please suggest.
Thanks & Regards
Hi I'm from CA
Maybe I didn't put my question properly.
1- How can we determine which location is needed for smoke detection and where the detector should be installed.
2- How do we choose which kind of smoke detector to install in a corridor, bedroom, cabin, or restroom? Does it depend on how...
Hello,
I am working on smoke deduction routing for an Aircraft Interior. Could anyone please help in understanding about Sniffer Ports like,
i) I have an input saying to use 4 sniffer ports but are there any parameters to select no of sniffer ports required per sqft?
ii) We have an input which...
Hi, It need to be created with parametric features and I'm not allowed to use synchronous modelling. Also, I should try my best to not to use surfacing
Thanks & Regards
Hello everyone,
Wish you all a Merry Christmas!
I'm writing this thread to seek your help/suggestions. I'm trying to convert one body into parametric in NX. This body has a strange irregular profile. Could you please help me or give me some suggestions on how I can achieve the shape? or how my...
Hello,
Even after increasing the pitch, I'm unable to match the profile.
My thread requirements
Major Dia 59.53
Minor Dia 51. 05
Pitch 5.08
Thread length: 15.24
Angle; 60
Can someone please help? I tried nearly 10 iterations still failed
Thanks & Regards
I have observed one more issue, the helix I have added is 3 turns, first 2 turns were matching with dumb solid but 3rd turn is not matching.. Any idea?
Thanks & Regards
Hello,
I need some critical help on Helix Cut in UG NX 11. I'm converting one dumb solid to Parametric part. I didn't understand where I went wrong in making a Helix cut, I have added helix and Thread triangle. I have tried couple of times but failed. Could anyone help me on this? I have...
Hello All,
I'm preparing a checklist that should comply with ASME 14.100 Drafting standards. Does anyone has reference for check list? That would help drafters to reduce the errors before submitting to delivery. Could anyone help on this?
Thank you for your time and support
Thanks & Regards
Hi Dave,
Somehow convinced them for GIMP in our official system, they will install in couple of days. Can we achieve the similar comparison outcome from GIMP?
Thanks & Regards
Hi Dave,
Thank you for detailed explanation, photshop is working good in my personal computer but unable to install in my office PC due to IT restrictions. Is there anyway to simply create a small software or tool only for this purpose?
Thanks & Regards
Hello,
Is there any open source software like Autovue to compare engineering drawings? The comparison result should show in colors what is deleted and what is added. Please suggest.
Thanks & Regards
Thank You for your response.
I found few images in google, any idea how they might be formed/constructed. I'm very interested to know about 1st image (Engine Bay-1). I didnt see any support frames for this type. How that would be possible? OR was structural frame covered with a thin sheet...
Thank you all for your responses.
In previous batch we were using Rivets and welding but I'm exploring new method of Joints other than Rivet/Weld for upcoming batch. If we are not satisfied with new method, we may endup going with rivets/weld again. Before concluding, I wanted to make sure...
Hello All,
I have TWO aerostructure frames that needs to be Joined rigidly using any NAS approved fasteners or any other type of Hardware, after assembly that joint should feel and act like a Permanent Joint. I thought of using tensile lock bolts but not sure on the rigidity, yet to do the...
