Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Section Lines are not visible in Break View
John, Your right, and if you close and reopen saved part section will migrate right back to layer 257. {So not data bankable as stable part!} I needed a work around to keep moving just like some other users. There been 4 PR's opened turned to ER's since April and this not fixed yet. This August...- ADJ1
- Post #9
- Forum: Siemens: UG/NX
-
Section Lines are not visible in Break View
John, Your right, and if you close and reopen saved part section will migrate right back to layer 257. {So not data bankable as stable part!} I needed a work around to keep moving just like some other users. There been 4 PR's opened turned to ER's since April and this not fixed yet. This August...- ADJ1
- Post #7
- Forum: Siemens: UG/NX
-
Section Lines are not visible in Break View
John, If you look in the part navigator the section lines are being placed on layer 257! In NX this layer does not exist, if you select them use the move command and place them on the correct layer you good to. As for the section letters you need to either suppress the view break and copy them...- ADJ1
- Post #5
- Forum: Siemens: UG/NX
-
Why are so many companies so scared or unwilling to upgrade NX to the newest version?
till NX 8.5, I have never had so many issues!!!!!!! Several IR's both Modeling and Drafting. Code issues that should have never been released.- ADJ1
- Post #11
- Forum: Siemens: UG/NX
