Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. Silambarasan

    Wide Coil processed product tolerance

    Hi, We received a SA240 Gr.316L coil product of 10 mm thickness. While referring Table A3.13 of SA480 Ed.2013 for thickness tolerance, we observed that maximum thickness given in the table is 8 mm. Then what will be the thickness tolerance for 10 mm coil. Whether the same for 8 mm is applicable...
  2. Silambarasan

    Raw material used for flanges

    Hi Mike, Me too assuming the same, Thanks for your information Regards M.V.Silambarasan
  3. Silambarasan

    Raw material used for flanges

    Hi SnTMan, We had purchased two different sizes of flange, one is 2" WNRF 300# & another special type flange as per end user's requirement of OD230 36mm thk. i'm unaware about the flange manufacturing process, SA182 Para6.4.1 states 'shall not be machined directly from bar' which means you can...
  4. Silambarasan

    Raw material used for flanges

    Hi, We had purchased flanges(SA182 F316L) from a vendor, while reviewing their test certificate i came across the 'raw material used' column which says SS Round bar. ASME Section VIII Div.1 UG-14 says 'Except for flanges of all types, hollow cylindrically shaped parts may be machined from rods &...
  5. Silambarasan

    Re:ERW pipe in Pressure Vessel

    Thanks for your response. Its a 'U' stamp job. Code of construction - ASME Sec VIII Div 1
  6. Silambarasan

    Re:ERW pipe in Pressure Vessel

    Whether ERW pipe can be used in pressure vessels??

Part and Inventory Search

Back
Top