Hi People,
Could you, please, explain me what is the "difference" between these two curves?
When I use one and when I use the other in FEA/FEM studies?
Thanks in Advance.
WPZ
Dear Sirs,
What SOL into Femap I need to use to simulation velocity events?
For example, one block which beat in another one which is fixed? One simple sample/example, please...
Is it a transient / dymanic study?
Thanks a lot
Regards,
WPZ
Hi Dears,
I would like to run one simple drop test using FEMAP (Nastran) but I cannot do this uo to now.
Has someone some example and can share with me? There is no techinical papers in internet about it.
I need o know how I can set up the data inside the software.
Kind Regards,
Thank you...
Dear Friends,
If I have one single bar (square profile, 5x5mm and 30mm length - for example), I put one fixed restrain at end and applies one force in other (not compress force, but one force to bend the bar) I can solve it easily using the IMPLICIT method (Static Linear or NL, whatever)...
Dear Colleagues,
I have one issue regarding the Von Mises, Tresca, Int. Principal Stress application in FEM.
- When I may use one or another (for example, which I can use to ABS or PP material and for one regular Steel material)?
- What are te difference between them?
- What is the best for...
Hi Guys,
I need to performance one Metal Cutting Simulation using FEA and I would like to know if someone has this kind of knowledge. In fact, I know I have to use the EXPLICIT mode and the better for it are ABAQUS and LS-DYNA. There some technical papers showning ALE method, SPH method, and...
Hi Guys,
I need to performance one Metal Cutting Simulation using FEA and I would like to know if someone has this kind of knowledge. In fact, I know I have to use the EXPLICIT mode and the better for it are ABAQUS and LS-DYNA. There some technical papers showning ALE method, SPH method, and...
I have LS-DYNA solver and I would like to use Femap as the Pre-Post; Is there anybody here who did it?
How is the Femap interface to run LS-DYNA? Any restrition or something like that?
I need to figure out how to do CUTTING SIMULATION (Explicit Mode).
Thank you very much.
Wagner
